Help with JV-880 and JV-2080 set-up, please/ I've just bought both of those units from eBay, and am puzzled. Been using 2 x JV-1010s for some years without any hassles. I cannot get these two new units to respond to channels 9-16 from my sequencer. 1-7 and channel 10, yes, I've read the handbook until my eyes rolled out onto my chin, but I can't see how to make every patch accessible via every channel. They seem to be accessible only to one channel. But The 1010s default to 16 channels on start-up. I did a factory reset on the two 'new' mixers as soon as they were powered up. Why can't my software drive them on 16 different channels, like the JV-1010s (and by the way my dear old TG-100)?? Using Genisoft Overture Version 4.1, by the way. Be grateful for any advice. I must not be doing something very basic and simple... Stephen Gard
