Need instructions on installing GR9-E1 expansion board in gr09

Discussion in 'alt.music.synth.roland' started by MES Jones, Dec 24, 2009.

  1. MES Jones

    MES Jones Guest

    Bought an extra used synth and board. Been years (and chemo+radiation)
    since I installed the one in my first synth. Memory is a bit fuzzy.
    (chemo will do that).
    TIA, mes.
     
    MES Jones, Dec 24, 2009
    #1
    1. Advertisements

  2. MES Jones

    S - E - A Guest

    Don't know, but if it is like the expansion boards that the JV's use,
    then it should be a case of removing the expansion board plate, fitting
    the board, ensuring the clips are rotated 90 degrees to hold the board
    in place. Not forgetting to replace the expansion cover plate.

    Here is a link to the manual for the GR-09, but it tells you to refer to
    the expansion board manual for fitting the expansion board. I've not
    found a link for that manual.

    ftp://ftp.roland.co.uk/ProductSupport/Manuals/GR-09_OM.pdf

    On 24/12/2009 17:21, MES Jones wrote:
    > Bought an extra used synth and board. Been years (and chemo+radiation)
    > since I installed the one in my first synth. Memory is a bit fuzzy.
    > (chemo will do that).
    > TIA, mes.
    >
     
    S - E - A, Dec 25, 2009
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.