Keyboard Stand: any ideas for extending the front stops?

[Treuzberg]

Hi everyone,
I recently bought a Quik Lok QL/723 three-tier keyboard stand and I’m trying to improve one small aspect of the setup.

I have a Roland Gaia 2 on the middle tier, which I keep tilted at roughly 40°. This angle is actually perfect for playing while seated and gives me very comfortable access to the controls and, more importantly, it is the only practical position I found that is compatible with the geometry of the third tier.

The problem is that the small L-shaped plastic stops at the ends of the support arms are quite short and, since the Gaia has a somewhat rounded bottom/front edge, I’m worried that enough movement could cause it to slide over the stops.

Under normal playing conditions I’m not particularly worried, but I live in an earthquake-prone area, so I’d prefer a more substantial mechanical stop rather than relying only on friction.

Has anyone dealt with something similar? I’d prefer not to drill or permanently modify the stand.

I’ve attached a few photos: first is the actual stop, second one shows how the rounded front/bottom profile of the Gaia does not sit very securely against the original L-shaped stop, and third one shows why I cannot simply reduce the tilt angle: the horizontal arm of the middle tier would interfere with the vertical support of the third tier.

Any ideas or photos of similar setups would be very welcome.
Thanks!

 

[hubalken]

When I was using my second tier, I used an On Stage Stands model coupled to my On Stage double x braced main stand. The ends on the second tier were a little taller than the ones you show pictured. I never had any problems with the second keyboard moving around or sliding off. I still have my second tier but don't use it anymore since I am now primarily a piano player and have both of my digital pianos set up side by side in my music room. Perhaps in the future, I'll employ it again. Anyway, you might want to look into the On Stage Stands model of second tier add on. I think I purchased mine for about $50.00 from Sweetwater Sound. Just a suggestion. Hopefully this will remedy your issue. If I remember correctly, the On Stage Stands model is compatible with most other keyboard stands. I would check the specifications of it along with the inside diameter of the tubular supports of your current stand(if applicable). It should say what the requirements are on Sweetwater's website. Anyway, I hope this helps you out.
Best wishes.

 

[Jon80]

Hi everyone,
I recently bought a Quik Lok QL/723 three-tier keyboard stand and I’m trying to improve one small aspect of the setup.

I have a Roland Gaia 2 on the middle tier, which I keep tilted at roughly 40°. This angle is actually perfect for playing while seated and gives me very comfortable access to the controls and, more importantly, it is the only practical position I found that is compatible with the geometry of the third tier.

The problem is that the small L-shaped plastic stops at the ends of the support arms are quite short and, since the Gaia has a somewhat rounded bottom/front edge, I’m worried that enough movement could cause it to slide over the stops.

Under normal playing conditions I’m not particularly worried, but I live in an earthquake-prone area, so I’d prefer a more substantial mechanical stop rather than relying only on friction.

Has anyone dealt with something similar? I’d prefer not to drill or permanently modify the stand.

I’ve attached a few photos: first is the actual stop, second one shows how the rounded front/bottom profile of the Gaia does not sit very securely against the original L-shaped stop, and third one shows why I cannot simply reduce the tilt angle: the horizontal arm of the middle tier would interfere with the vertical support of the third tier.

Any ideas or photos of similar setups would be very welcome.
Thanks!

 

[Jon80]

Being the DIY type, I’d extend the vertical part of the L by slipping a short piece of rubber hose over it, and securing it in place with wire or a zip tie under the post. Just need to drill a hole in either side of the hose at the bottom. I’ve found rubber against plastic prevents slipping, too. Pretty primitive, but most of my rigs are. Good luck!